Where 50 Hz hum comes from
Across Europe, Africa, Australia and the larger part of Asia, the grid alternates at 50 cycles per second. North America and much of South America run at 60 Hz instead, and Japan is split in two: Tokyo and the east on 50 Hz, Osaka and the west on 60 Hz, a leftover from the German and American generators each region bought in the 1890s. If you live in a 50 Hz country, this is the pitch any mains leak into your audio will have.
Hum is rarely a clean 50 Hz. Magnetic coupling and rectification add harmonics at 100, 150 and 200 Hz, and which one dominates is a clue. A smooth, deep drone at 50 Hz usually means induction or a ground loop between two devices. A coarser buzz centered on 100 Hz more often comes from a power supply, because full-wave rectification doubles the mains frequency. The 60 Hz page walks through the fixes; they apply unchanged here, with 50, 100 and 150 Hz in place of 60, 120 and 180.
Matching hum in a recording
Hum in a recording carries the grid frequency of the place it was made. A podcast taped in London hums at 50 Hz; the same setup in Chicago hums at 60. That matters when you clean it up: a hum filter set to 60 Hz and its harmonics will leave 50 Hz hum almost untouched, so check which one you are dealing with before you cut anything.
The quickest check is the spectrum analyzer. Play the hum near your microphone and read the peak: a tall line at 50 Hz with smaller ones at 100 and 150 Hz is mains hum. Grids hold their frequency to within a fraction of a hertz, so a peak at 46 or 55 Hz is more likely a fan, a motor or a room resonance, and no amount of grounding work will touch it.
50 Hz as a bass test tone
Musically, 50 Hz sits about 35 cents above G1 (49.0 Hz), the note you get at the third fret on the lowest string of a four-string bass. Phone and laptop speakers are far too small to move enough air at that pitch, so on them this page will sound faint or silent. Headphones that seal well, or any speaker with a proper woofer, will play it.
On a subwoofer, 50 Hz is a good rattle finder. Play it at a moderate level and walk around the room: a buzzing shelf, window pane or loose grille gives itself away quickly. You will also hear the level rise and fall as you move - those are the room's standing waves, not a fault in the speaker. For the rest of the low end, the subwoofer test sweeps down from 150 Hz, and the bass test shows how low your system really goes.